STM32L151 for Virginia Tech's camera experiment on AMSAT's FOX-1 satellite
http://i.imgur.com/WvimSAF.jpg
https://github.com/mitchd/vt-fox-1
Running ChibiOS 2.4.3 with some modifications for the processor and LQFP144 package. I forget exactly what I had to do to enable the peripherals I wanted, but they weren't quite fully implemented yet.
Post your PCB
Re: Post your PCB
@ErikZalm
What is it? Industrial controller?
@MitchD
What the IC between camera and MCU? Is it RAM?
What is it? Industrial controller?
@MitchD
What the IC between camera and MCU? Is it RAM?
Re: Post your PCB
I built an expansion board for the F4Discovery some time back.
About: http://www.theembeddedkitchen.net/stm32/an-expansion-board-for-the-stm32f4discovery/
Audio player based on it: http://www.theembeddedkitchen.net/stm32/cs43l22-audio-playback-and-sdio-stm32f4discovery-board/
Pics:
Boardception ( A board within a board within a board )
http://www.theembeddedkitchen.net/wp/wp-content/uploads/2014/03/boardception.jpg
http://www.theembeddedkitchen.net/wp/wp-content/uploads/2014/03/discovery1.jpg
http://www.theembeddedkitchen.net/wp/wp-content/uploads/2014/03/boardstack.jpg
About: http://www.theembeddedkitchen.net/stm32/an-expansion-board-for-the-stm32f4discovery/
Audio player based on it: http://www.theembeddedkitchen.net/stm32/cs43l22-audio-playback-and-sdio-stm32f4discovery-board/
Pics:
Boardception ( A board within a board within a board )
http://www.theembeddedkitchen.net/wp/wp-content/uploads/2014/03/boardception.jpg
http://www.theembeddedkitchen.net/wp/wp-content/uploads/2014/03/discovery1.jpg
http://www.theembeddedkitchen.net/wp/wp-content/uploads/2014/03/boardstack.jpg
- Giovanni
- Site Admin
- Posts: 14455
- Joined: Wed May 27, 2009 8:48 am
- Location: Salerno, Italy
- Has thanked: 1076 times
- Been thanked: 922 times
- Contact:
Re: Post your PCB
Something from my side:
http://abload.de/img/board_sideu0jg0.jpg
http://abload.de/img/board_topk5kgp.jpg
An SRAM and some LC-Filters are not populated yet. An SSD1963 based 5" touchscreen goes on top of that board (connector at the right edge).
~ Tectu
http://abload.de/img/board_sideu0jg0.jpg
http://abload.de/img/board_topk5kgp.jpg
An SRAM and some LC-Filters are not populated yet. An SSD1963 based 5" touchscreen goes on top of that board (connector at the right edge).
~ Tectu
- Giovanni
- Site Admin
- Posts: 14455
- Joined: Wed May 27, 2009 8:48 am
- Location: Salerno, Italy
- Has thanked: 1076 times
- Been thanked: 922 times
- Contact:
-
- Posts: 359
- Joined: Sat Jan 07, 2012 6:22 pm
- Location: Brazil
- Has thanked: 1 time
- Been thanked: 20 times
- Contact:
Re: Post your PCB
"Arbitrary Waveform Generator by Joel Bodenmann"... looks more like a signal generator!
Ah, I'd never heard of SiliconBlue FPGAs before, interesting! Very nice board, btw!
Ah, I'd never heard of SiliconBlue FPGAs before, interesting! Very nice board, btw!
Re: Post your PCB
Giovanni wrote:What's that? an oscilloscope?
It is an arbitrary signal generator. Three channels, DC to 20MHz each, -12 to +12V with full range offset, three selectable filter banks (or bypass).
The hardware mainly consists of an STM32F102CB, an STM32F407ZGT and an ICE40HX FPGA. And it runs ChibiOS/RT & µGFX, of course
utzig wrote:Very nice board, btw!
Thanks, my "biggest" board so far (four layer, 0.1mm traces and impedance matching and all the crap).
~ Tectu
Who is online
Users browsing this forum: No registered users and 17 guests