Hi,
sorry, may be, this is not the right place to ask this question: anybody managed to compile the community-supported HAL CRC driver with the Chibios 18.2.1? I've got a bunch of compilation errors. Earlier I used the same driver with the ChibiOS_17.6.3 with no problem.
Regards,
Vladimir
Chibios 18.2.1 and CRC driver
-
- Posts: 35
- Joined: Fri Feb 09, 2018 12:44 am
- Has thanked: 2 times
- Been thanked: 5 times
- Giovanni
- Site Admin
- Posts: 14455
- Joined: Wed May 27, 2009 8:48 am
- Location: Salerno, Italy
- Has thanked: 1076 times
- Been thanked: 922 times
- Contact:
Re: Chibios 18.2.1 and CRC driver
Hi,
Probably you just need to remove the parameter to the rccDisableXXX() macros, this is the main change.
Community code is not maintained and can be not aligned to latest changes.
Giovanni
Probably you just need to remove the parameter to the rccDisableXXX() macros, this is the main change.
Community code is not maintained and can be not aligned to latest changes.
Giovanni
-
- Posts: 35
- Joined: Fri Feb 09, 2018 12:44 am
- Has thanked: 2 times
- Been thanked: 5 times
Re: Chibios 18.2.1 and CRC driver
Thank you, Giovanni! I've added the 'low power mode' parameter to the rccEnableXXX() call. And it did the trick!
Also I had to add the hal_community.h and halconf_community.h to the project.
Regards,
Vladimir
Also I had to add the hal_community.h and halconf_community.h to the project.
Regards,
Vladimir
Who is online
Users browsing this forum: No registered users and 11 guests