Hello every body,
Two or three weeks ago, I added to the trunk my first port for ATtiny167 micro-controller .
I plan to support a wide range of ATtiny devices, but for the moment, this is the starting point.
The port is based on digispark pro board from Digistump here is a link to the website: http://digistump.com/products/109
There are RT and NIL demos under demo/AVR/ NIL-DIGISPARK-ATTINY-167 or demo/AVR/RT-DIGISPARK-ATTINY-167. The two demos use a thread to blink an onbaord LED and also send a message on UART Transmission pins.
For the moment, I have implemented just the minimum of low level drive (uart and pal) so a lot of work are still reminding on the hal layer.
Give a try for those who are interested, and I hope it will give a lot of idea to other people.
Feedback, suggestions and improvements are welcome.
ChibiOS/(NIL & RT) support for ATtiny167 Topic is solved
- tfAteba
- Posts: 547
- Joined: Fri Oct 16, 2015 11:03 pm
- Location: Strasbourg, France
- Has thanked: 91 times
- Been thanked: 48 times
Re: ChibiOS/(NIL & RT) support for ATtiny167 Topic is solved
Hello everyone,
Just a short message to tell that I have share this work with the Digistump community in case there will be interested people.
Here is a link to the post: http://digistump.com/board/index.php/topic,2798.0.html
I will see if there will be emulation around this small board running ChibiOS/RT and ChibiOS/NIL.
Just a short message to tell that I have share this work with the Digistump community in case there will be interested people.
Here is a link to the post: http://digistump.com/board/index.php/topic,2798.0.html
I will see if there will be emulation around this small board running ChibiOS/RT and ChibiOS/NIL.
regards,
Theo.
Theo.
Who is online
Users browsing this forum: No registered users and 7 guests