Hi,
What is replacing irq_vector_t and vectors_t in v18.2.n?
I'm using those to access the vector table and check for a valid address. In this new version the vectors are now in an assembly file...
If the above don't exist anymore, is there a recommendation on how to replace them and achieve the same purpose?
Thanks!
irq_vector_t and vectors_t in v18.2.n
Moderators: RoccoMarco, lbednarz, utzig, tfAteba, barthess
-
- Posts: 91
- Joined: Sat Feb 18, 2017 11:50 am
- Has thanked: 43 times
- Been thanked: 23 times
- Giovanni
- Site Admin
- Posts: 14455
- Joined: Wed May 27, 2009 8:48 am
- Location: Salerno, Italy
- Has thanked: 1076 times
- Been thanked: 922 times
- Contact:
Re: irq_vector_t and vectors_t in v18.2.n
Hi,
You could take the header from the previous version and use the definitions, the table layout is exactly the same, alternatively you can use offsets using the VTOR registers as a base.
Giovanni
You could take the header from the previous version and use the definitions, the table layout is exactly the same, alternatively you can use offsets using the VTOR registers as a base.
Giovanni
Who is online
Users browsing this forum: No registered users and 16 guests