Page 1 of 1

How can I program a SPC56M from Ubuntu?

Posted: Thu Dec 22, 2016 7:47 pm
by antonioalfonso
Hello to all of you, I'm going to program a board of STMicroelectronics SPC56M with spc5studio, but use ubuntu. I tried some plugin for eclipse, since spc5studio is based on it, but found nothing. I was advised to ask you, does anyone know how I could do? Maybe if I can use an IDE other than STStudio ??

Thanks for your attention!!

Re: How can I program a SPC56M from Ubuntu?

Posted: Thu Dec 22, 2016 9:13 pm
by Giovanni
Hi,

I don't think there is much Linux support for SPC5, you should see if HighTec and Lauterbach have Linux-based solutions.

Giovanni