Hello everyone,
I got this nucleo board with the 144 pin L4 series. 1mb flash and 320kb ram. I see there is a L476xx, can i use this or do i have to make a new port? if so, how?
Thanks!
STM32 L496ZG
Moderators: RoccoMarco, barthess
- Giovanni
- Site Admin
- Posts: 14444
- Joined: Wed May 27, 2009 8:48 am
- Location: Salerno, Italy
- Has thanked: 1074 times
- Been thanked: 921 times
- Contact:
Re: STM32 L496ZG
Hi,
That specific device is not yet supported, it does not require a new port, just an update of the existing L4 port. Usually this involves:
1) Updating the L4 headers from ST.
2) Adding an entry in stm32_registry.h.
3) Changes in hal_lld.h/.c (if required).
4) Testing.
Giovanni
That specific device is not yet supported, it does not require a new port, just an update of the existing L4 port. Usually this involves:
1) Updating the L4 headers from ST.
2) Adding an entry in stm32_registry.h.
3) Changes in hal_lld.h/.c (if required).
4) Testing.
Giovanni
Who is online
Users browsing this forum: No registered users and 24 guests