Hi
According to the datasheet, it seems possible to use TIM14 CH1 as a PWM, but I don't see support for TIM14 in the hal pwm code.
Is there some restrictions?
Thanks
NUCLEO-F042K6 and PWM on TIM14 Topic is solved
Moderators: RoccoMarco, barthess
- Giovanni
- Site Admin
- Posts: 14444
- Joined: Wed May 27, 2009 8:48 am
- Location: Salerno, Italy
- Has thanked: 1074 times
- Been thanked: 921 times
- Contact:
Re: NUCLEO-F042K6 and PWM on TIM14 Topic is solved
Hi,
Some timers are not supported because IRQ sharing issue with other timers, a solution is being analyzed but it will take time.
You could extend the driver easily, patches have also been submitted for that but you would have problems enabling the conflicting timers in other drivers.
Giovanni
Some timers are not supported because IRQ sharing issue with other timers, a solution is being analyzed but it will take time.
You could extend the driver easily, patches have also been submitted for that but you would have problems enabling the conflicting timers in other drivers.
Giovanni
Who is online
Users browsing this forum: Bing [Bot] and 17 guests